Adjusting basic position of camshaft

WIS 05-2240

Adjusting basic position of camshaft – rysunek
Adjusting basic position of camshaft – rysunek

Preceding work: Front cover removed (01-2120). Basic position of camshaft checked (05-2230).

Crankshaft 0.2.0… eee eee ee eee rotate until TDC marking on vibration damper is aligned with TDC pointer (arrow). Crankshaft 2.000 eee rotate to TDC of cylinder 1 with hexagon socket size 27 and torque wrench 000 589 10 99 01. Chain tensioner (15) ………….0000 eee remove (05-3100). Timing chain (8) ……………2 22a eee lift off camshaft sprocket (7).

mime §=RA 05.1123-2240/1

Adjusting basic position of camshaft – rysunek
Adjusting basic position of camshaft – rysunek

Camshaft sprocket (7) 2005 rotate with wrench (10) 116 589 10 07 00 until setting hole (21) in the camshaft is matched with the cast marking (20) on first camshaft bearing bracket.

A Ensure that the valves do not strike the piston crown when rotating the camshaft. Pay attention to note.

install (05-3100). Chain tensioner rotate two revolutions in direction of rotation of Crankshaft engine. Check basic position of camshaft (05-2230).

mie §=RA 05.1123-2240/2

Adjusting basic position of camshaft – rysunek

Special tools

Note

Adjusting basic position of camshaft – rysunek

In crankshaft position 30° before TDC at cylinder 1, the camshaft can be rotated without the valves coming into contact with the piston.

wiite §=RA 05.1123-2240/3