Checking and replacing hydraulic valve clearance compensating
WIS 05-2110
Preceding work: Warm engine up to operating temperature (80 °C) Cylinder head cover removed (01-0500).
POS – 5239 – 57
Checking (compensating element installed) Crankshaft ……………0–0 000020200 rotate and position cam of compensating element (58) to be checked to base circle. Hydraulic compensating element (58) ……… apply load with handle of hammer or similar for approx. 5 — 10 seconds (arrow).
Do not press valves against piston when testing pressure. If compensating element (58) drops, there is a leak on the inside and it must be replaced. Remove relevant camshaft bearing cap (05-2320).
mie §=RA 05.1123 – 2110/1
check play between compensating element (58) lf compensating element (58) does not drop, …. and rocker arm (51) by hand. If play exists between hard compensating check basic position of compensating element element (58) and rocker arm (51), (05-2130). Camshaft bearing cap remove (05-2320).
5240 – 55
Checking (compensating element removed) Compensating element (58) press out of rocker arm (51) with washer using aluminium or brass drift.
Compensating element (58) position vertical. Oil supply chamber (a) fill with engine oil. Ball valve (63) open with wire (1) (dia. approx. 1.5 mm). push down as far as stop and release. Repeat Pressure pin (64) operation as often as necessary until working chamber (b) is filled with engine oil. Pressure pin (64) of vertical compensating element (58) press down firmly with handle of hammer or similar for approx. 10 seconds. If pressure pin (64) drops, replace compensating element (58).
wie =—RA 05.1123 – 2110/2
Oss P05 – 5241–13
Replacing
push into rocker arm (51) until it touches snap Washer (57) and compensating element (58) ring. must be facing compensating element (58). Grooves (arrow) of washer (57) …………. Rocker arm bearing bracket with ball socket (55) 6… ee ee ee eee install (05-2190). Basic position of hydraulic compensating element 2.0.2.0… eee ee eee eee check (05-2130).
Note \f the compensating elements do not drop, check whether oil drillings in cylinder head in rocker arm bearing bracket, rocker arm shaft and rocker arm are clear. Clean oil drillings if necessary. If several compensating elements are soft, check whether oil nozzle return jock in cylinder head is tightly seated, replace if necessary (18-4150). Adjust oil to correct level (oil foaming).
wai §=RA 05.1123 – 2110/3



