Testing oil pressure

WIS 18-0070

Testing oil pressure – rysunek
Testing oil pressure – rysunek

P18-5324–57

1 0 – 10 bar pressure gauge 103 589 00 21 01 6 Seal

2 T valve BS Oil pressure sensor

3 Pressure pipe A 7 Oil filter

4 Pressure pipe B 10 Rpm meter

5 M12 1.5 pipe fitting X11 Diagnostic socket

Engine oil temperature ……………0— set to 90 °C Oil level in engine 00.00.00 ce eee check, adjust to correct level (18-0020) Oil pressure sensor (B5) ……………205. remove, install Threaded pipe fitting (5) with seal (6) ……… screw on in place of oil pressure sensor (B5) Pressure gauge (1) with pressure pipe (3) …… connect

wii = =—RA 18.11133-0070/1

T valve (2) at pressure gauge (1) ………..-. close (turn to closed position) Oil pressure at stated engine speed ………. measure and compare with figures in table

Engine oil pressure (reference values) 2)

Engine speed in rpmat 90 °C engine oil temperatureEngine oil pressure in bar at 130 °C engine oil temp.
6001)0.70.6
7500.90.9
10002.01.3
20004.33.5
30004.64.4
4000484.6
50005.04.7

‘) With drive position engaged 2) At operating temperature the oil pressure at idle speed must drop to 0.3 bar. When the throttle is depressed, the oil pressure must rise immediately and be at least 3 bar al an engine speed of 3000 rpm.

Special tool

Testing oil pressure – rysunek

f

f 04 \ 103589002100 =

Commercially available tools

M12x 1.5 pipe fitting (5) 915 006 004 002 (DIN)

Rpm meter (10) eg. engine tester or multimeter

mine = RA 18.11133-0070/2

Note re oil pressure relief valve

Testing oil pressure – rysunek

The damped oil pressure relief valve with 2 flats (arrows) at the piston (4) is integrated in the oil pump and opens at a pressure of 5 bar.

4

B 3

1 2

– 37

Screw plug OOD Pressure chamber (feed) PON Compression spring (102.9 mm long) Suction chamber (return) Guide pin (45 mm long) Damping chamber Piston with 2 flats

auime = RA 18.11133-0070/3