Engine oil and filter change

WIS 18-0020

Engine oil and filter change – rysunek

Preceding work: Operation no. of operation texts and work units or standard texts Warning instructions when hood open (01-0085). and flat rates Avr cleaner removed (09-1031). 00-6200

Specified viscosity

classes according to

SAE at prolonged

outside temperatures

P18-5179-33A

Precise use of the SAE classes according to the Refer to the „Service Product Specifications” for outside air temperatures would necessitate further information on specified viscosity classes frequently changing engine oil. The temperature and approved engine oils. limits for the SAE classes should therefore be regarded as a guide which may be transgressed for brief periods.

Oil capacity in litres

Engine Model Capacity when Dipstick marking (see 18-3500) changing oil and filter Color marking Numbering on handle (color red)

103 107, 124, 6.0 red – 126, 201

103 124 6.5 red – 4MATIC

103 129 6.51) – 10308

103 201 AMG 5.52 2) red –

103.987 462.2 7.0 3) – – ’) 6.1 liters with dipstick guide tube 1st version (up to 05/1992) 2) Oil level when checking between Min. and Max. 3) 6.5 with sand-cast oil sump

wimp RA 18.1133-0020/1

Replaceable cartridge 20 Screw cover

Engine oil and filter change – rysunek
Engine oil and filter change – rysunek
Engine oil and filter change – rysunek

Special tools

Commercially available tool103589020900
Engine oil extractoreg.Deutsche Tecalemit Am Metallwerk 11 D~33659 Bielefeld

me RA 18.1133-0020/2

Engine oil and filter change – rysunek

AN Change engine oil only when engine at normal operating temperature.

1 Before draining or extracting the engine oil, unscrew replaceable cartridge (579) with the wrench socket 103 589 02 09 00. Strike the wrench socket 103 589 02 09 00 lightly to ensure that it is properly located on the interchangeable cartridge (579).

When unscrewing cartridge, a little oil may flow out until the return lock in the cartridge (579) closes.

For this reason, place cleaning rags or similar below the unscrewing surface on the bottom section of the oil filter.

Engine oil and filter change – rysunek

2 Extract engine oil through the dipstick guide tube when engine at normal operating temperature.

If no extractor is available:

3 Drain engine oil from sump (arrow).

Engine oil and filter change – rysunek

Installation instruction Renew seal of oil drain plug. Tightening torque 25 Nm.

4 On 4MATIC models, unscrew only the drain plug (arrow) at the large oi! sump (4).

Installation instruction

Renew seal of oil drain plug. Tightening torque 25 Nm.

Engine oil and filter change – rysunek

5 Clean connection surface at bottom of oil filter.

6 Apply a light coating of oil to gasket (arrows) of the new replaceable cartridge.

Engine oil and filter change – rysunek

P18-2030–13

7 Screw on replaceable cartridge (579) and tighten by hand.

Following this, tighten cartridge a further 1/4 turns (90°) with the 74 mm wrench socket 103 589 02 09 00 (approx. 20 Nm).

8 Pour in engine oil.

9 Run engine and check for signs of leaks.

10 Wait approx. 2 minutes after switching off the warm engine before checking oil level.

ite RA 18.1133-0020/4