Testing cooling system pressure cap

WIS 20-430

Testing cooling system pressure cap – rysunek

Operation no. of operation texts and work units or standard texts and flat rates

P20-0120–35

Double union 000 589 776300 …………. connect to leaktightness tester 124 589 15 21 00 (step 1). Cooling system pressure cap …………..-. fit onto double union 000 589 73 63 00 (step 2). Opening pressure ………….—2000008 test (step 3).

Pressure cap

Pressure cap code numberPressure relief valve opens at bar gauge pressure newusedVacuum valve opens at bar vacuumTest pressure for pressure-testing cooling system in bar gauge
1201.2+0.11.2 -0.10.11–1.3
140 as of see table1.4+0.11.4–0.10.11–1.3

ui §=RA 20 1133-4300/1

Testing cooling system pressure cap – rysunek
Testing cooling system pressure cap – rysunek

Special tools

000589776300 /

Note

Testing cooling system pressure cap – rysunek

If corrosion is present on expansion tank cap, renew Cap.

The opening pressure of the cap has been increased from the previous 1.2 bar to 1.4 bar which in turn increases the permissible coolant temperature from 125 °C to 129 °C when standard antifreeze protection exists down to -30 °C.

Expansion tank cap 1.4 bar, production breakpoint

Model Vehicle Ident End No.

107 12.1987 A 081220 124 10.1987 A 619444 124 12.1987 F 061097 126 12.1987 A 388193 201 10.1987 A 416011 201 12.1987 F 451531

wale RA 20.1133-4300/2

Testing cooling system pressure cap – rysunek
Testing cooling system pressure cap – rysunek

To ensure no outside air is drawn in at this cap (when vacuum exists in cooling system), it is provided with a rubber seal (A).

Caps with and without guide ring (B) are factoryfitted. Only the cap with guide ring is supplied as a replacement part, however.

The modified cap can also be installed in cars with coolant expansion tank manufactured prior to this date.

A Seal B_ Guide ring

Testing pressure relief valve

Testing cooling system pressure cap – rysunek

1 Attach double union 000 589 73 63 00 to leaktightness tester 124 589 15 21 00.

2 Fit cooling system cap onto double union 000 589 73 63 00.

3 Test the opening pressure by pumping.

P50-2010–13

Testing vacuum valve

Testing cooling system pressure cap – rysunek

The vacuum valve (arrow) must be resting against the rubber seal; it should be possible to raise it slightly and, when released, it should spring back into place.

Note Corroded (surface rust) expansion tank caps should be replaced.

P20-2171.13,