Testing cooling system for leaks

WIS 20-0170

Testing cooling system for leaks – rysunek

Operation no. of operation texts and work units or standard texts and flat rates

Pressure cap (1) 2… ..00 0.2. e eee eee open in stages, close

A The pressure cap (1) should not be opened unless the coolant temperature is below 90 °C. If engine is hot, on no account remove the cap (1) before releasing the pressure in the cooling system. Risk of scalding! Coolant level in expansion tank ……….-.. check, top up if necessary (20-0100) Connection cap (3) of tester (2) lock at filler neck of coolant expansion tank. Special tool 124 589 15 21 00 Cooling system… 2. ee eee pressurize with tester (2) (about 1.4 bar)

«mate RA 20.1133-0170/1

All connections of coolant and heating water hoses ……..—-.-.-0 20: eee eee check for loss of coolant and also examine exterior condition of coolant hoses and hose straps; replace in necessary or re-tighten hose straps.

Tightening torques in Nm (reference values) 1)

Hose clips up to @ 27 mm (waf 6 mm)2.5
Hose clips as of @ 28 mm (waf 7 mm)3.5

1) Threaded hose clips which are excessively tightened damage the hoses.

Special tool

Testing cooling system for leaks – rysunek

Commercially available tool

7 mm socket wrench hexagon on flexible eg. Hazet, D-42853 Remscheid shaft for hose straps with wormdrive Order no. 426–7

vege = RA 20.1133-0170/2