Sealing coolant pump
WIS 20-2250
Preceding work: Coolant pump removed (20-2100).
13 M6 x 20 bolt + washer
Spiral housing (6) …………….0.0000unscrew, screw on (10 Nm). O-ring (7) 2… eee eee replace. Puller (14) 000 589 94 3300 …………… position at impeller (5). Grips of puller (14) 2.0.0.0… 0.00. 0..00088 tension with sleeve ID 40 mm (shop-made) or suitable hose strap. Impeller (5)… eee pull off. Counter-ring (3)… 6.2 ee pull off with pliers.
mime RA 20.1112-2250/1 press out of coolant pump (1) around Cassette-type seal (4) circumference with a screwdriver.
A Do not damage coolant pump (1), use clean rag as base.
P20-5219–57
Mount for cassette-type seal (4) clean
Note Sealant is applied to the circumference of the cassette-type seal (4). press in as far as stop with a 40 mm dia. New cassette-type seal (4) sleeve.
«mite RA 20.1112-2250/2
Counter-ring (3)… 2… ee ee ee eee ee fit onto pump shaft with ground face toward seal (4a). Impeller (5) 2… ee ee eee eee heat to approx. 100 °C. Impeller (5)… ee ee ee ee eee press on. Size (a) (5.6–5.8mm) ……………–4observe. Tight seat of impeller (5) on pump shaft ……. check.




