Removing and installing two-mass flywheel

WIS 03-4620

Removing and installing two-mass flywheel – rysunek

Preceding work: Operation no. of operation texts and work units or standard texts Manual transmission removed (26-020). and flat rates Clutch removed (25-050). Holding lock for crankshafVring gear installed (03-5000)

Stretch bolts (12) 2.2.0.0… 0.02. ee eee eee unscrew, screw on. Stretch bolts (12) ……………..002005 check, see table. Stretch shaft below minimum dia. (d) ……… replace stretch bolt (12). Two-mass flywheel (1) …………….00. remove, install. Dowel pin (10) 2… 2… eee eee note.

wu RA 03.1123-4620/1

Data

Thread (D)M101
Stretch shaft dia. (d)when new8.5 – 0.2
minimum dia.8.1
Bolt length (L)when new5740.2
Tightening torque Initial torque40 Nm + 90° tightening angleangle

Special tool

Removing and installing two-mass flywheel – rysunek
Removing and installing two-mass flywheel – rysunek

Note If no angle of rotation torque wrench is available, the stretch bolts can be torqued further by the specified angle with a wrench socket and lever in a single operation. To eliminate angularity errors, do not use a bending rod torque wrench for tightening to angle of rotation torque. Design of two-mass flywheel, see „Function of two-mass flywheel (03-4600)”. The two-mass flywheel must not be treated with preservation agents. Reconditioned engines for the two-mass version are supplied only in the automatic transmission version. The two-mass flywheel from the old engine should be used or replaced, if damaged.

A The two-mass flywheel cannot be serviced and is Supplied as a replacement part.

wie =RA 03.1123-4620/2

Two-mass flywheel, production breakpoint: 08/1989 Engine end no. Vehicle ident end no. Model Engine manual automatic transmission transmission A F

027793 103.940 * 124.026 026999

124129 124.030 103.983 033313 031824 124.050 124.090

124.226 103.943 069100 000447

124.230 124011 103.985 037643 002138 124.290

Start of series production 129.060 103.984

201.029 103.942 508036 640695 014907

Start of series production 463.2 103.987

Two-mass flywheel with super wide angle damping, production breakpoint: 07/1991

Model Engine Engine end no. Vehicle ident end no. manual automatic transmission transmission A F

124.026 103.940 036032

201.029 103.942 019743

124.030 103.983 043968 124.050 124.090

129.060 103.984 000736

463.2 103.987 000854

mie =RA 03.1123-4620/3