Checking, replacing and tightening conrod bolts

WIS 03-3100

Checking, replacing and tightening conrod bolts – rysunek

Operation no. of operation texts and work units or standard texts and flat rates 03-4341, 03-4351

Stretch shaft bolt (1st version) L — Part no. 102 038 00 71

Thread dia. (d) M9 x 1 „

Stretch shaft dia. (c) Cc when new 7.4–0.1 i>

Minimum stretch shaft dia. {(c) 7.1

Length (L) when new §2 -0.3

P03-0100–13.

Tightening torque in Nm

Stretch shaft bolt Initial tightening torque 7) 30

Angle of rotation torque 90 – 100° 2) Thread and contact surface of bolt head moistened with engine oil before fitting.

Checking, replacing and tightening conrod bolts – rysunek

Flow shaft bolt (2nd version)

Part no. 102 038 02 71

Thread dia. (d) M9 x1 v Shaft dia. (c) so

when new 8.7 – 0.2 A

Minimum shaft dia. (c) 8.2

Length (L) when new 52–0.3′)

1) Re-use conrod bolt up to max. 52.9 mm. – 13

aie RA 03.1123-3100/1

Tightening torque in Nm

Flow shaft bolt Initial tightening torque ”) 30 (40) 5)

Angle of rotation torque 90 – 100° 2) Thread and contact surface of head of bolt moistened with engine oil before fitting. 5) For initial tightening.

Flow shaft bolt (8rd version)

Part no. 111 038 00 71

Thread © M9 x 1

Checking, replacing and tightening conrod bolts – rysunek
Length (L) when new 52–0.3′)
) Re-use conrod bolt up to max. 52.9 mm Tightening torque in NmP03-5270–13
Flow shaft bolt Initial tightening torque 7)35 (45) 5)

Angle of rotation torque 90 – 100°

2) Thread and contact surface of head of bolt moistened with engine oil before fitting. 5) For initial tightening.

Conrod bolts 2… eee eee eee re-use up to minimum stretch shaft dia. or up to max. flow shaft length. Different weight ……………..2..-06. note (see note). Thread and bolt head contact surface ……… oil before fitting. Conrod bolts ………..00002 tighten initially with torque wrench 001 589 66 21 00. Conrod bolts 2.2.2.2 ee eee tighten with angle of rotation wrench. Pay attention to note.

Special tool

Checking, replacing and tightening conrod bolts – rysunek

Cee al RA 03.1123-3100/2

Note The conrod bolts of the three versions have different weights. Only the same conrod bolts may be installed in an engine.

If no angle of rotation torque wrench is available, the conrod bolt can be tightened further by the specified angle with a socket wrench and lever in a single operation. To eliminate angularity errors, do not use bending rod torque wrenches for tightening to angle of rotation torques.

we RA 03.1123-3100/3