Replacing core hole closing cover in cylinder crankcase

WIS 01-140

Special too!

Replacing core hole closing cover in cylinder crankcase – rysunek

Mandrel for knocking-in dae core hole closing covers – 102 589 00 15 00

Note Core holes in cylinder crankcase are closed with sheet metal covers (34 mm dia.).

Replace leaking closing covers on principle.

At the right (driving direction) the closing plug (M 38 x 1.5) remains in place.

Replacing core hole closing cover in cylinder crankcase – rysunek

Driving direction left oo .

This core hole can be used to insert cooling water preheater.

Replacing core hole closing cover in cylinder crankcase – rysunek

Driving direction right

Transmission end issi

Replacing core hole closing cover in cylinder crankcase – rysunek

Replacemen

1 Completely drain coolant.

2 Remove components which obstruct access (e.g. transmission, intermediate flange, injection pump etc.).

Replacing core hole closing cover in cylinder crankcase – rysunek

Drain plug on cylinder crankcase

3 Position a chisel with a narrow blade or a screwdriver into deep drawn edge of closing cover.

Replacing core hole closing cover in cylinder crankcase – rysunek

4 Carefully knock closing cover on one side down until cover has turned around its own longitudinal axis (approx. 90°).

Replacing core hole closing cover in cylinder crankcase – rysunek

5 Position water pump pliers against flange of projecting section and pull out closing cover.

Replacing core hole closing cover in cylinder crankcase – rysunek

6 Thoroughly clean core hole from residue. Sealing surface should be free of grease (arrow).

7 Coat core hole with sealing glue, part no. 002 989 94 71.

Replacing core hole closing cover in cylinder crankcase – rysunek

8 Knock-in new closing cover by means of mandrel.

9 Attach removed components.

10 Add coolant.

Note: The sealing glue should cure for approx. 45 minutes before adding coolant.

11. Run engine warm and check for leaks.