Cleaning the colling system

WIS 20-015

A. De-oiling

1 Completely drain cooling system.

2 Remove thermostat element and set heater lever to warm.

3 Fill cooling system with a 5 % solution of water and P 3 Standard (made by Henkel) (50 g P3/1 water water).

Attention ! On vehicles with aluminum radiator, a neutral cleaner such as P 3 Croni (made by Henkel) or Grisiron 7220 (made by Farhwerke Hochst) must be used instead of the heavily alcaline cleaner P 3 Standard.

4 Run engine warm at medium sneed up to approx. 80°C (176°F) and hold at this temperature for about 5 minutes.

5 Stop engine and permit cooling system to cool down to approx. 50°C (122°F).

6 Completely drain solution.

7 Immediately thereafter, fill cooling system twice with fresh water, run warm (approx. 5 minutes) and drain.

B. Decalcification, derusting

Attention ! Prior to decalcification, be sure to de-oil cooling system, even if there is no visible oiling-up.

ing system with a 10 % (100 g/I) solution of water and citric acid, tartaric acid or oxalic acid (sold by the chemical trade), while giving preference to citric acid.

2 Run engine warm at medium speed up to approx. 80°C (176°F) and hold for approx. 10 minutes at this temperature.

3 Stop engine and permit to cool down to approx. 50°C (122°F).

4 Completely drain decalcification solution.

5 Flush cooling system at least three times with fresh water, while running engine for at least 5 minutes with each flushing charge.

Badly calcified cooling systems may require a repetition of the treatment. Always prepare a fresh decalcification solution and repeat flushing steps.

6 Install thermostat element with new seal.

7 Fill the cooling system with specified coolant specification for service products page 310 to 325).

Note: For decalcification and derusting, commercial products named with the acids nemed above may also be used.

Chromic acid or products containing chromates are prohibited by sewage regulations.