ARO5.00-P-2011HX Removing, installing hydraulic valve clearance compensation elements (bucket 13.10.97

WIS 05-2011hx

ARO5.00-P-2011HXRemoving, installing hydraulic valve clearance compensation elements (bucket tappets)13.10.97
ENGINE 601, 602, 603 (except, 602.982)a
ARO5.00-P-2011HX Removing, installing hydraulic valve clearance compensation elements (bucket 13.10.97 – rysunek

1 Valve clearance compensation element

2 Rubber suction cup

3 Oil gallery in cylinder head

4 Seal

5 Screw plug Arrows Oil feed drillings to compensation elements

i Ed] Removing, installing

1 Remove camshaft

2Pull out compensation element (1)EP fi) Installation: re-install compensation elements (t) which are not replaced, at the same point. Oil compensation element (1).WHS58.30-Z-1008-02A
3Remove screw plug (5) and blow compressed air into oil gallery (3)i) At the same time, inspect clearance of outlet drillings (arrows) at the seat of the valve tappet. [i] installation: replace seal (4).
4Install in the reverse orderBn
Commercially available tools (see Workshop Equipment Manual)Oo
NumberDesignationMake (e.g.)Order number
WH58.30–7-1008-024,Rubber suction cup @ 30mmHazet Gildenwerther BahnhofstraBe 25–28 D-42857 Remscheid735–2