Adjusting engine stop
WIS 22-220
Preceding work: Operation no. of operation texts and operation values or standard Bottom engine compartment lining removed (01-006). texts and flatrates ……….——….02.. 22-2111
P22-0042–53
Note For this adjustment, the vehicle must be standing on its wheels ready for the road. The engine stop must not be treated with oil or grease. slacken at front engine stop, tighten, Adjusting bolt (1) 130 Nm insert gauge 201 589 04 23 00 remove (steps 1, 3 – 7).
Note Slacken prepared engine stop from frame cross member.
slacken at rear engine mount, tighten, Adjusting screw (11) ……….00. 30 Nm (steps 2, 5).
Tightening torques
| Adjusting bolt, front engine stop | 130 |
| Adjusting screw, rear engine mount | 30 |
Special tools
c \
f Ea – 001 589 66 21 00
A
wim RA 22.1044-220/1
Slackening
Note To adjust the engine stop, the vehicle must be ready for the road and be standing on its wheels. The engine stop must not be treated with oil or grease.
1 Slacken adjusting bolt (1) at engine stop (2) fully.
Note Slacken engine stop which is sticking to frame cross member as a result of wax or paint.
04 Gauge 201 589 04 23 00
2 Slacken adjusting screw (11) at rear engine supporting bracket fully.
12 Engine supporting bracket 14 Engine mount hexagon bolts
Adjusting
3 insert gauge 201 589 04 23 00 (02) at engine stop.
4 Move engine by shaking slightly from left to right by hand.
5 Tighten adjusting screw at rear engine mount, 30 Nm.
6 Tighten adjusting bolt (1) at engine stop (2), 130 Nm.
7 Remove gauge (02).





