Removing oil from cooling and heating system

WIS 20-016

Removing oil from cooling and heating system – rysunek

Preceding work: Operation no. of operation texts and operation values or standard Coolant drained (20-010). texts and flat rates Coolant thermostat removed (20-110).

P20-0116–57

Heater control 2… 2… eee ee eee eee set to „warm” (step 1). Cooling system… eee eee eee fill with a 5 % flushing solution (step 2). Engine 22… ccc teens warm up to normal operating temperature and run for approx. 5 minutes (step 3). Flushing solution …………0 00.0000 e eae drain and fill cooling system twice with fresh water, run engine each time for approx. 5 minutes, completely drain flushing solution (steps 5 and 6). Cooling system… ee eee eee ee eee check for leaks (20-017).

wim §=6RA 20.1044-016/1

Removing oil from cooling and heating system – rysunek

Note Oil must be removed from the cooling system if e. g. engine oil, automatic transmission fluid on models fitted with automatic transmission, or hydraulic oil has got into the cooling system.

Removing oil

1 Set heater control to full capacity.

A On such vehicles (light alloy radiator) sharply alkaline cleaners such as P3 Standard (supplier: Henkel) must not be used.

2 Fill the cooling system with a 5 % solution of water and neutral cleaner or with a cleaner suitable for cold spraying, e. g. Neuproton 5226 (supplier: Henkel). ”

3 Warm up engine to approx. 80 °C by running at moderate rpm and maintain for approx. 5 minutes at this temperature.

4 Switch off engine and allow cooling system to cool down to approx. 50 °C.

5 Drain solution completely.

6 Immediately after this, fill cooling system twice with fresh water, warm up engine (approx. 5 minutes) and drain.

7 Check cooling system for leaks (20-017).

aim §=PRA 20.1044-016/2