Removing and Installing DSV Control Module, Engine 603.971

WIS 07.1-8823

Removing and Installing DSV Control Module, Engine 603.971 – rysunek

Operation no. of operation texts and work units or standard texts and flat rates: 6. ee eee 07-8823

P07-6702–15

Vehicle identification number (VIN) ……….. read with HHT from DSV control module (IN3/13) (see menu prompting in HHT, section diesel engine, „DSV” system, version coding).

Note The DSV control module (N3/13) and the RCL control module are assigned by means of an identification. This identification cannot be erased (see HHT actual values “drive authorization system” menu point 3 identification). It is therefore not possible to replace the DSV control module (N3/13) or the RCL control module with parts from another car as a check.

07.1.1064 – 8823/1

DSV control module remove, install; chisel securing bolt loose for this purpose (sheer bolt NP part no. 601 990 07 63).

Note Before first starting, the identification of the DSV control module (N3/13) with the RCL module must be started with the HHT. If it is necessary to perform adjustment work on the injection pump (pump removed), the DSV control module (N3/13) must be unbolted. lf anew DSV control module (N3/13)is installed for test purposes, it is essential to identify but not to interlock the control module. If the DSV control module (N3/13) does not remain in the car, the identification is retained until the data are overridden during the next identification process. This process can be repeated as often as desired until final interlocking is performed. If a control module is not interlocked, not more than 40 starts or ignition ON/OFF may be performed otherwise the control modules will then be permanently Interlocked.

Removing and Installing DSV Control Module, Engine 603.971 – rysunek

False memory

07.1.1064 – 8823/2

Removing and Installing DSV Control Module, Engine 603.971 – rysunek

Test

Removing and Installing DSV Control Module, Engine 603.971 – rysunek

Engine separation point connector X26/2

07.1.1064 – 8823/3

Actual value readout on HHT

Meanings of actual value displays in HHT

Removing and Installing DSV Control Module, Engine 603.971 – rysunek

70. YES Identification has already taken place. NO Non-identified control module with first installation on new control module.

YES No more new identification possible NO Identification can be re-started. The control module is automatically interlocked after 40 starts or ignition ON/OFF.

YES Fuel shutoff valve is switched to open. Engine can be started. NO. Fuel shutoff valve (N3/13y1) has not switched. Engine starts but cannot be revved up.

YES RCL closed, car locked. No start enabled, Open car with RCL. NO RCL not closed, car opened with RCL.

07.1.1064 – 8823/4