Removing and installing oll pump
WIS 18-2100
Preceding work: Operation no. of operation texts and work units or standard texts Bottorn engine compartment panel removed and flat rates (Maintenance Manual 6190). 18-6020-6025 Engine oil drained (18-0020).
Models 124, 129
2 M8 X 20 bolt with washer 6 M8 x65 bolt washer Dowel sleeves
5 M8 X35 bolt + washer 7
~able straps at bottom part of oil sump …….. detach, attach. Oil line (9) of automatic transmission at bottom part of oil sump (1)… ee ee eee unbolt, bolt on (9 Nm). If level control fitted: high pressure flexible hose (10) at bottom part of oil sump (1) unbolt, bolt on (9 Nm). Bottom part of oil sump (1) Lee eee eens unbolt, bolt on (9 Nm). Sealing surfaces 2.0… 0.0… ccc cee eee eee clean. Gasket (la)… ee replace.
aoiiie RA 18.1322-2100/1
Balancing weight of 1st crankshaft journal place horizontally. Oil level sensor (S43) at oil pump (4) unbolt, bolt on (18-3300).
aN Engine 119.97, see 18-3300. Bolt (2) of oil pump drive gear (3) slacken, tighten (28 Nim). Oil pump (4) at timing case cover unbolt, bolt on (21 Nrn).
Installation note Prevent tensioning spring (11) of tensioning bar from turning by inserting a screwdriver when tightening the bolt (6). tilt to the rear, unscrew bolt (2) and take off oil Oil purnp (4) pump drive gear (3) from oil pump (4), fit on.
Installation note Fit on oil pump drive gear (3) with curved side toward oil purnp (4) (arrows). Oil purnp (4) remove, install. fill with engine oil before installing. Oil pump (4)
nN sad A newly installed oil purnp (4) must be filled with engine oil to ensure it draws in oil after starting. remove, install, clean strainer. Balancing weight (4a)
Special tool
Note If the tensioning bar for the drive chain has to be replaced, the timing case cover should be removed (01-2100).
atin RA 18.1322-2100/2

