Removing and installing fuel gauge sending unit
WIS 47-120
A. Model 107
P47-0047–53
disconnect, connect. Battery ground cable detach, attach. Hardtop raise, lower. Soft top unclip, clip in. Cover detach, protect against slipping off, plug in. Connector at fuel gauge sending unit (B4) remove and instail, run to empty if necessary. Fuel gauge sensor (B4)
Note If fuel tank full, pump off approx. 8 liters beforehand. Renew seal. Remove locking pin below adhesive sheet (new part). Tightening torque 39 Nm.
47.0714 – 120.1
B. Model 126
P47-0048–53
Battery ground cable …………2.0–000, disconnect, connect. Backrest, rear bench seat …………..0.. remove and install (91-170). Cover… cee ee ees unclip, clip in. Connector on fuel gauge sensor (B4) ……… disconnect, protect against slipping off, plug in. Fuel gauge sensor (B4) ………….2-000, remove and install, run to empty if necessary.
Note If fuel tank full, pump off approx. 8 liters beforehand. Renew seal. Remove locking pin below adhesive sheet (new part only). Tightening torque 39 Nm.


