Removal and installation of return sprocket

WIS 05-440

Tightening torques

Nm

with 3 diaphragm springs’ ) Crankshaft end bolt front with 4 diaphragm springs! )

’) See Note 03-324.

Special tools

Torque wrench, single-arm, 3/4” drive, „00413802 – 001 589 74 21 00

Socket insert 27 mm, 1/2’ drive – 001 589 65 09 00

Detent (starter motor flange left or right) – 116 589 01 40 00

el Allen screwdriver with cross-bar handle 6 mm, 440 mm long Sleeve for radial sealing ring front – 110 589 07 61 00

Conventional tool

Adapter 3/4” inside to e.g. Hazet, D—5630 Remscheid 1/2″ outside drive Order No. 1058 R1 – 116 589 03 07 00

Note On engine 116 with duplex chain the intermediate sprocket can only be renewed after removal of the left-hand cylinder head.

The bearing bushings for the return sprocket in the crankcase have fallen away as from December 1984 and those in the timing case cover as from March 1985.

Removal and installation of return sprocket – rysunek

Removal

1 Remove timing case cover (01—210).

2 Remove slide rail (87).

3 Slacken timing chain on intermediate sprocket (78) by turning left-hand camshaft.

4 Remove intermediate sprocket (78).

5 Remove return sprocket (1).

Removal and installation of return sprocket – rysunek

6 If required, pull out bearing bushing in crankcase by means of internal puller

7 Pull out bearing bushing in timing case cover with internal puller.

Installation

Removal and installation of return sprocket – rysunek

8 Press bearing bushing into crankcase and timing case cover with lubricating groove at the bottom (arrow).

9 Lubricate bearing bushing in crankcase with oil and introduce return sprocket.

10 Install intermediate sprocket (05—434).

11 For further installation proceed vice versa.