Checking and replacing hydraulic valve clearance compensating elements

WIS 05-211

Tightening torques

Nm

Bolts for cylinder head cover

Compensating element in cylinder head 60

Special tool

Checking and replacing hydraulic valve clearance compensating elements – rysunek

Spring compressor for valve spring – 123 589 03 61 00

Note Store compensating elements in upright position only and do not disassemble.

Reinstall rocker arms and compensating elements in the same place from which they were removed.

Checking and replacing hydraulic valve clearance compensating elements – rysunek

In the event of complaints about noise, check compensating elements as follows:

Checking

1 Place cam tip opposite rocker arm in upward position.

2 Push with handle of a hammer against rocker arm.

If the ball head pressure bolt drops too fast when compared with other pressure bolts, replace hydraulic valve clearance compensating element.

Checking and replacing hydraulic valve clearance compensating elements – rysunek

3 Try to move rocker arm manually.

\f there is play, check basic position of compensating elements (05–213).

Replacing

Checking and replacing hydraulic valve clearance compensating elements – rysunek

4 Remove rocker arm (05—230).

Checking and replacing hydraulic valve clearance compensating elements – rysunek

5 Unscrew compensating element with 24 mm socket.

6 Lubricate threads of new compensating element, screw in and tighten to 60 Nm.

7 Install rocker arm (05-230).

8 Check basic position (05—213).

05.7-211/2, F 3