Removal and installation of intermediate sprocket ignition distributor drive

WIS 05-434

Tightening torques Nm

Screw on crankshaft front

Front screw for camshaft sprocket 100

Special tools

Torque wrench single arm, 3/4” square, – 001 589 31 21 00

Socket 27 mm, 1/2″ square – 001 589 65 09 00

Detent (starter removed) – 116 589 01 40 00

Screw driver with tommy handle 6 mm, 440 mm long s9066187 – 116 589 03 07 00

heat \ Sleeve for radial sealing ring front – 110 589 07 61 00

Conventional tool

Connection 3/4” square socket to e. g. made by Hazet, D—5630 Remscheid 1/2″ square head order No. 1058 Ri

Removal

Removal and installation of intermediate sprocket ignition distributor drive – rysunek

1 Remove timing housing cover (01—210).

2 Remove slide rai! (87).

78 Intermediate sprocket for ignition distributor drive

3 Slacken timing chain on intermediate sprocket by turning on lefthand camshaft.

4 Remove intermediate sprocket.

5 Pull out bearing bushing in cylinder crankcase and in timing housing cover by means of internal puller.

Installation

Removal and installation of intermediate sprocket ignition distributor drive – rysunek

6 Press bearing bushing into cylinder crankcase and into timing housing cover so that the lubricating groove (arrow) comes to rest in downward position.

7 Provide bearing bushing with oil and introduce intermediate sprocket.

W39559

Removal and installation of intermediate sprocket ignition distributor drive – rysunek

8 Set crankshaft to ignition TDC.

Attention! At ignition TDC position of 1st cylinder, the intermediate sprocket should be positioned in such a manner that the applied markings on intermediate sprocket and on cylinder crankcase are in alignment (arrow).

Engine 116

Removal and installation of intermediate sprocket ignition distributor drive – rysunek

PWN Driver Mark on intermediate sprocket Mark on crankcase Reference point for crankcase without mark

Engine 117

9 Check position of intermediate sprocket and correct, if required.

Marks (arrows) should be in alignment, if not, the ignition distributor on engines with breakerless controlled ignition system cannot be installed with the required adjustability.

10 For further installation proceed vice versa.