Adjustment of throttle vaive switch

WIS 07.4-140

Adjustment of throttle vaive switch – rysunek

a) With Bosch tester EFAW 228

1 Connect Bosch tester EFAW 228 (07.4—040). Move switch ,,A”’ to position ,,measuring’’, switch ,B” to position ,,throttle valve switch III’.

2 Loosen switch (1) and the two fastening screws (2 and 3).

3 Switch-on ignition and turn switch until pointer of test instrument moves from ,,%”’ to ,,0’. From this position move switch by 1/2 graduation mark (19) counterclockwise and tighten. Then check adjustment by actuating throttle valve.

b) Without Bosch tester

Adjustment of throttle vaive switch – rysunek

1 Run engine at idle.

2 Pull-off supplementary air hose between supplementary air valve and idle speed air distributor.

3. Insert a0.4 mm measuring gauge at idle stop of throttle valve housing, with engine running. Adjust throttle valve switch, if required.

Note: To check, insert a 0.35 mm measuring gauge at idle speed stop.

Adjustment is in order, if engine is hunting. Repeat adjustment, if required.

Remove measuring gauge and reattach supplementary air hose.