Facing cylinder crankcase parting surface

WIS 01-120

Data

Height of cylinder crankcase when new 242.8–242.9

Minimum height following required removal of material 242.5

in longitudinal direction 0.08 Perm. unevenness of parting surface To a ae in transverse direction 0.05

Perm. roughness of upper parting surface 0.006–0.016

Perm. deviation in parallel of upper parting surface in 01 relation to longitudinal direction

Pressure test with air under water in bar gauge pressure (atu) 2

Facing cylinder crankcase parting surface – rysunek

Chamfer of cylinder bores refer to note

Note Cylinder bores are chamfered after facing.

\f the cylinder crankcase parting surface has been reconditioned, reset the timing (05–215).