Cleaning the cooling system

WIS 20-015

A. De-oiling

1 Completely drain coolant.

2 Remove coolant thermostat and, on vehicles with and without air conditioning, set heating regulation to full heating output. On vehicles with automatic climate control (model 123), depress push-button ‘‘DEF”.

3 Fill cooling system with a 5 % solution of water and cleaner, e.g. P 3-Standard (made by Henkel) (50 g cleaner/1 liter water).

Attention! On vehicles with aluminum radiator, a neutral cleaner or a midly alcaline cleaner, e.g. P 3-Croni (made by Henkel) or Grisiron 7220 (made by Farbwerke Hochst) must be used instead of the heavily alcaline cleaner P 3-Standard.

4 Run engine warm at medium speed up to approx. 80 °C (176 °F) and hold at this temperature for about 5 minutes.

5 Stop engine and permit cooling system to cool down to approx. 50 °C (122 °F).

6 Completely drain solution.

7 \Immediately thereafter, fill cooling system twice with fresh water, run warm (approx. 5 minutes) and drain.

B. Decalcification, derusting

Attention! Prior to decalcification, be sure to de-oil cooling system, even if there is no visible oiling up.

1 After second flushing job during de-oiling, fill cooling system with a 10% (100 g/I) solution of water and citric acid, tartaric acid or oxalic acid (sold by the chemical trade) while giving preference to citric acid.

2 Run engine warm at medium speed up to approx. 80 °C (176 °F) and hold for approx. 10 minutes at this temperature.

3 Stop engine and permit cooling down to approx. 50 °C (122 °F).

4 Completely drain decalcification solution.

5 Flush cooling system at least 3 times with fresh water while running engine for at least 5 minutes with each flushing charge.

Badly calcified cooling systems may require a repetition of the treatment. Always prepare a fresh decaicification solution and repeat flushing steps.

6 Install coolant thermostat with new sealing ring.

7 Fill the cooling system with coolant (20—010).

Note: For decalcification and derusting, commercial products made with the acids named above may also be used.

Chromic acid or products containing chromates are prohibited by sewage regulations.