Checking, adjusting float level

WIS 07.2-180

Testing and adjusting values

Float needle valve 2.25

Sealing ring for float needle valve 1.5mm

Float level (ball pushed in) 16–17 mm

Self-made tool

==

Checking, adjusting float level – rysunek

47 Gage for measuring float level 5 !

Adjusting

1 Check float level, adjust.

For this purpose, push float carefully down until

spring-loaded ball of float needle valve (39) is

completely pushed in.

Checking, adjusting float level – rysunek

Check float level with measuring gage or slide gage at highest points of float.

If a correction of loat level is required, check first whether sealing ring (173) under float needle valve (39) has specified thickness of 1.5 mm. Renew sealing ring, if required.

Then correct float level with float remove by bending lug (arrow) as required.

Bending device

Bending toward float needle valve = increasing float level

Bending away from float needle valve = decreasing float level

Attention! When rebending lug, make sure that lug is pressing vertically on float needle. The two solid floats should be vertical in relation to measuring gage. Re-align, if required.