Checking compression
WIS 01-010
Test values in bar for engine at operating temperature
| Engine | Compression ratio ε : 1 | Compression normal | Min. compression | Max. difference between separate cylinders |
|---|---|---|---|---|
| Normal compression | 9.0 | 10–12 | approx. 8.5 | max. 1.5 |
| Low compression: USA, S, J starting 1976; AUS starting 1977 | 8.0 | 9–10 | approx. 7.5 |
Special tool
Compression recorder with attachments and contact grip. – 001 589 46 21 00
Notes
Check compression with coolant at temperature of 80° C.
Check cylinders for leaks if compression is less than the minimum specification (01–015).
Unscrew all spark plugs for testing.
Checking
Models 107, 114 and 116
Connect contact handle to battery + and terminal 50 on starter.
Disconnect cable on ignition coil terminal 1.
Model 123
Connect contact handle to terminal 30 and to terminal 50 on cable connector.
Disconnect cable on ignition coil terminal 1.
Attention! On engines with CIS injection system, pull-off relay with code number 21 (3) for fuel pump—warm-up compensator.
Model 126
Separate cable plug, arrow terminal 16, so that the ignition coil, and on engines with CIS the fuel pump, cannot be activated. Connect terminal 30 and 50.
1 Rotate engine for several turns with ignition switched off and idle speed or selector lever position »P”’ so that residue and soot will be blown out.
2 For testing, rotate engine for eight turns while opening throttle valve.





