Testing and adjusting TN choke for function

WIS 07.2-130

Testing and adjusting values

TN control piston overlap at + 85 °C coolant temperature0.8–1.0 mm
TN control window opening at + 20 °Capprox. 2.5 mm

Special tool

Clamp 6190 M006- – 000 589 40 37 00

Conventional tool

Combined slide and depth gauge

Testing and adjusting TN choke for function – rysunek

Testing, adjusting

1 Run engine to operating temperature (coolant thermostat opened (approx. 85 °C).

2 After loosening the two fastening screws (arrows) pull out TN choke with water hoses connected.

TN choke version 2 with enlarged expansion element and housing

Testing and adjusting TN choke for function – rysunek

3 Test and adjust TN control piston position. For this purpose, after pulling out TN choke, immediately measure dimension ‘’X“’ from face up to upper edge of control window directly adjacent to web.

Attention! Measuring is required immediately because upon cooling down the expansion element will respond and cause control piston to move to another position.

Measuring dimension “’X*’

Testing and adjusting TN choke for function – rysunek

4 Then measure dimension ““Y’’ from face up to edge of control piston.

Dimension “Y” should be 0.8–1.0 mm smaller than dimension “’X’’, so that the control piston will close control window with overlap.

TN control piston overlap: at + 85 °C coolant temperature 0.8–1.0 mm.

Measuring dimension „Y”’

Testing and adjusting TN choke for function – rysunek

5 Adjust TN control piston position by means of adjusting screw.

Screwing out = reducing overlap

Screwing in = increasing overlap

Testing and adjusting TN choke for function – rysunek

Note: At + 20 °C temperature of TN choke, the TN control window should be open by approx. 2.5 mm. Each 10 °C of temperature change will cause control piston to travel approx. 0.5 mm, i.e. at approx. 70 °C coolant temperature the control window is just closed. At approx. 0 °C the control window is wide open.

6 Pinch coolant hoses on TN choke and pull off.

7 Let TN choke cool down below + 20 °C (e.g. tap water) and then measure TN control window opening ate a

Nominal value: min. 2.5 mm.

(If contro! window opening is essentially less, replace TN choke).

8 Reinstall TN choke.

07.2.2 la~130/2