Removing and installing follower at camshaft

WIS 05-2178

Preceding work: Warning instructions when hood open (01-0085)

Engine 104.980/981/990

Removing and installing follower at camshaft – rysunek
Removing and installing follower at camshaft – rysunek

Model 124. 2.0… ee ee ee eee stew remove viscous fan clutch, install (20-3120). Model 140: ………… sce we eee enue take off fan shroud ring at fan shroud, place over fan, install (20-3400). Shielding Cap (11). cee eee cee ee eee ee unclip on both sides, take off, fit on. ignition cable 1 at HT distributor (12) ……… unplug, plug in. High tension distributor (12) ….. wee eee seen unbolt, tilt up, install. Distributor rotor (6) and follower (4) ………. remove, install.

‘Note The slot of the follower (4) must engage in the locating pin (arrow) in the camshaft, (16 Nm). Protective cap (2) and seal (3) ………..2.. take off, fit on.

othe RA 05.1225-2178/1

Tightening torques in Nm

Distributor rotor to follower (reference value) 2,5

Follower to carnshaft (Torx) 16

Removing and installing follower at camshaft – rysunek

pecial tools

wie RA 05.1225-2178/2