Removing and installing air-to-oil cooler
WIS 18-1300
Operation no. of operation texts and work units or standard texts and flat rates:
A. Model 124 with air-to-oil cooling
Vehicle 2… ee ee eee see ew eee scenes drive onto lift platforrn or inspection pit. Front left panel (1) 6… eee ee ween nee remove, install. Oil pipes (7) and (8) to air-to-cil cooler (2) …… unbolt, bolt on (830 Nm) (union nut waf 32), pay attention to note. When performing this step ………. seeeeee counter-hold at air-to-oil cooler (2) with wrench (waf 27). Clip (5) ……….000- ras detach from fixture (11), fit on. Rubber block (4) 6… ee ee eee eee detach from bottom fixture (9), attach. Air-to-oil cooler (2) 6… ee eee detach from top fixtures (10 and 11), remove, install.
thie RA 18.1235-1300/1
Leaks check when engine warm.
Note
The oil circulates in the air-to-oil cooler (2) once the thermostat valve in the oil filter opens. Oil level check, adjust to correct level (18-0020).
Note
The spacers (1) must be positioned on the oil hose (2) so that they act as a buffer to the retaining clip (4). If the spacers (1) are not correctly installed, the oil hoses (2) may be chafed through and this may result in engine damage.
othe RA 18.1235-1300/2
B. Model 129 with air-to-oil cooling
Preceding work: Operation no. of operation texts and work units or standard texts Bottom engine compartment panel removed and fiat rates: (Maintenance Manual 6190) 418-6820
Bumper 2.6 eee eee Lene een wees detach from cooler supporting brackets (7), attach. Cil pipes (1) at air-to-oil cooler (2)… eee eee unbolt, bolt on (30 Nrn). Locking elements (5). see ee eee ee ee ees pull off from bearing pins (3), fit on. Air-to-oil cooler (2)… eee Dee teens disconnect at mounting brackets (8), fit on. Air-to-oil cooler (2) between bumper and cooler support ……- see e ew eenes seen a remove, install. Le@akS ccc ee eee ee ee eee eee nee check when engine warm.
Note The air circulates in the air-to-oil cooler (2) once the thermostat valve in the oil filter opens. Oillevel 66. ee eee eee Lee eee eee check, adjust to correct level (18-0020).
otie §=RA 18.1235-1300/3
C. Model 140 with air-to-oil cooling
Preceding work: Operation no. of operation texts and work units or standard texts Bottom engine compartment pane! removed and flat rates: (Maintenance Manual 6190) 18-6820
Oil pipes (1) at air-to-oil cooler 2.2.2… seus unbolt, bolt on (80 Nm). 6) secs unscrew, screw on. Metal holder ……….. see eee dee eae remove, install. Air-to-oil cooler ………… seen e eee see lift out from mounting points, insert. Leak$ 2… eee cee eee eens check when engine warm.
Note The ail circulates in the air-to-oil cooler (2) once the thermostat valve in the oil filter opens. Oillevel o 2… eee eee ee check, adjust to correct level (18-0020).
otiin RA 18.1235-1300/4





