Changing engine oll and filter
WIS 18-0020
Preceding work: Operation no. of operation texts and work units or standard texts Warning instructions when hood open (01-0085) and flat rates: Model 140: Air cleaner removed. 00-6200
Screw cover (2)… ee eee eee eee sees unscrew with wrench socket insert (05) 103 589 02 09 00 so that engine oil in oil filter flows off into sump. Screw cover (2) and oil filter element (4) …… remove. extract through dipstick guide tube (5a) when Engine oil engine at operating temperature. drain out of sump if no extraction device Engine oil ……. eaeee cece e wees available; remove bottom engine compartment panel for this operation (see Maintenance Manual 6190). Unscrew oil drain plug (arrow). Seal on oil drain plug (arrow) vee replace. Oil drain plug (arrow)… ee eee ee see eee screw on (25 Nm).
athe §=RA 18.1234-0020/1
Seal (3) in screw cover (2) wk eee replace. New oil filter dlement (4) 2.0.5… eee insert into oil filter. Screw cover (2)… ccc eee ween oe install, tignten (25 Nrn). Gap (19) ….0. vee eee eee see eee eae . open, pour in engine oil. Engine ………..00. rs run, check for leaks. Oil level 6.2… seen vee eee eee . check at dipstick (5) approx. 2 minutes after switching off warm engine.
Special tools
SAE specified viscosity classes at prolonged outside temperatures
Exact use of SAE classes on the basis of the outside air temperature would necessitate frequently changing the engine oil. The temperature limits for the SAE sag sare
classes should therefore be regarded as a guide ragarded as % e ling which may be transgressed for short periods. Reference should be made to the ’Specifications for Service Products” for further information regarding specified viscosity classes and approved engine oils.
tiie = RA 18.1234-0020/2
Oil drain plug to oil sump 25
Screw cover 25
Note Dipstick identification see (18-3500).
wtiin = RA 18.1234-0020/3



