Flushing cooling and heating system
WIS 20-0150
Preceding work: Operation no. of operation texts and work units or standard texts Warning instructions when hood open (01-0085) and flat rates: Coolant drained (20-0100)
Coolant thermostat ……………..000.. remove and install pressure-opened thermostat part no. 000 589 74 63 00, remove (step 1). Flushing connection pipe (01) ………….0install and connect tap water hose (steps 2 and 3). Cooling system… ke eee eee eee see wee flush (steps 4 to 9). Cooling system 6… eee ee eee ee tees see check for leaks (20-0170).
tiie =RA 20.1234-0150/1
Special tools
000 989 08 25
Note High coolant temperatures and low heating capacity may be caused, for example, by deposits of corrosion products in the radiator or in the heat exchanger.
The deposits are recognizable as a jelly-like mass or, when the radiator is ernptied and dry, from a grey layer on the radiator connection pipes. In this case, flush the cooling and heating system with water. If the cooling pipes of the radiator are already completely or partially clogged by deposits, the radiator must be replaced.
Procedure
1 Remove coolant thermostat and install pressure-opened thermostat 000 589 74 63 00 with seal.
gttin §=RA 20.1234-0150/2
2 Fit flushing connection pipe (01) 117 589 00 90 00 together with connection hose (02) between radiator and coolant hose.
3 Fit a tap water hose (03) onto the flushing connection pipe (01).
P20-2142-13A
4 Open cap of expansion reservoir.
5 Set heater to „warm”.
6 If model fitted with circulation pump, switch on circulation purnp.
To do this, switch on ignition and: a) On models with automatic heater, set temperature selectors to „Max” position.
b) On models with air conditioning (automatic), press „Defrost” pushbutton.
7 Open bleeder valve of auxiliary heater.
8 Run engine at about 2500 rpm and flush cooling and heating system for about 15 minutes with flowing water.
The cooling systern must always be cornpletely filled during the flushing operation. Regulate the quantity fed in accordingly.
9 Drain the flushing water completely in the radiator and crankcase; tighten drain plugs (17 and 82). Replace seal (18).
10 Remove flushing connection pipe and connect coolant hose to the radiator.
11 Install normal coolant thermostat with new seal.
12 On models fitted with stationary heater, connect plastic hose to bleeder valve and open valve.
13 Pour in fresh coolant (20-0100).
14 Check cooling system for leaks (20-0170).
aman = RA 20.1234-0150/3




