Removing and installing EZL/AKR control unit

WIS 15-2093

Removing and installing EZL/AKR control unit – rysunek

Operation No. of operation texts and work units or standard texts and flat rates:

Vacuum connection (4) 2.2… 2.0.22… eee ee detach, fit on. Coaxial connector for control cable frorn crankshaft position sensor (2). 2… unplug, plug in. 8-pin connector (A) 6… ce ee ee unplug, plug in. 8-pin connector (B) 2… ee ee eee unplug, plug in. 3-pin connector, knock sensors (1)… 2.2… unplug, plug in. EZL/AKR trimming plug connector (R16/2) ….. unplug, plug in. Fastening nuts for EZL/AKR control unit (N1/3) .. unscrew, screw on (3 nuts). Pay attention to washers. EZUAKR control unit (N1/3) 2 ee remove from stay bolt, fit on.

Note Heat conducting paste has been applied to the rear of the control unit and covered with heatconducting protective foil for improved heat dissipation. The protective foil must not be removed.

iin =RA 15.1212-2093,1

CIS-E control unit fault mernory read out, erase if necessary (see Diagnosis Manual Engine, Volume 2, Index 0).

Note Stored faults which may originate from test work resulting from cables being disconnected or from a simulation, rust be erased in the fault memory after cornpleting the work.

Notes

Since September 1989 a control unit with modified map and fault memory prograrnme part has been phased in.

Removing and installing EZL/AKR control unit – rysunek

Production breakpoint

Removing and installing EZL/AKR control unit – rysunek

Since October and November 1990, respectively, an ignition control unit with new map has been used.

Removing and installing EZL/AKR control unit – rysunek

124.051

ime = RA 15.1212-2093/2

Since April 1991 an EZt. ignition control unit with a modified map and a modified CIS-E control unit for the adjustment range of the inlet camshaft have been installed in order to reduce combustion noises. The total adjustment range of the inlet carnshatt is reduced to 29 °CA (previously 34 °CA). The inlat camshaft advance at part load above §000 rprn has likewise been reduced from 17 °CA to 14.5 °CA.

A The CIS-E control unit must only be installed together with the relevant EZL ignition contro! unit.

Production breakpoint: April 1991 (except Gs) Model Engine Engine end no. Engine end no. Manual transmission Automatic transmission

124.031 104.980 005792 025654 124.051 124.091

129.061 104.984 001134 010894

Since August 1991 an EZL. ignition control unit with modified software has been installed. Reason: starting-off in 1st gear.

Production breakpoint: August 1994 _ Model Engine Vehicle ident end no.

124.051 104.980 B 600485

amie §=RA 15.1212-2093/3