Removing and installing engine systems control unit (MAS)

WIS 15-2193

Removing and installing engine systems control unit (MAS) – rysunek

Operation No. of operation texts and work units or standard texts and flat rates:

Removal Locking handle (arrow) ………………. tum anti-clockwise fromm position „1” to position „0”. Engine systems control unit (N16) ……….. pull off upward.

Installation Engine systems control unit (N16)… 2.20.00. press vertically into connector. Locking handle (arrow) 2… …..2..004 see turn clockwise from position ”0” to position ”1”. Check that control unit is correctly seated in the connector by turning slightly back and forward. CIS-E control unit fault memory ……….0. . fread out, erase if necessary (see Diagnosis Manual Engine, Volurne 2, Index 0).

Note Stored faults which may originate fram test work resulting from cables being disconnected or from a simulation, must be erased in the fault memory after completing the work.

ihe =RAS.1212-219319

Note Revision of software on engine systems control unit (MAS). Storage of fault code 3 discontinued.

Removing and installing engine systems control unit (MAS) – rysunek

Production breakpoint: July 1990 Model Engine Vehicle ident Basic National version

antie RAI5.1212-2193/2