Removing and installing camshaft position sensor
WIS 15-2143
Operation No. of operation texts and work units or standard texts and flat rates:
>onnector of carnshaft position sensor (arrow) unplug, plug in. Screws (9) 2… ee ee ee unscrew, screw in. Tightening torque 10 Nm as reference value. Camshaft position sensor (L5/1) unplug, plug in. O-ring (11) 2… cee ce ee eee seen replace. CIS-E control unit fault memory read out, erase if necessary (see Diagnosis Manual Engine, Volume 2, Index 0).
Note Stored faults which may originate from test work resulting from cables being disconnected or from a simulation, must be erased in the fault memory after completing the work.
anihye RA 15.1211-2143/1


