Replacing core plug in crankcase
WIS 01-1400
Operaton no. of operation texts and work units or standard texts Preceding work: and flat rates Attachments in area of core plug removed. 01-8501 — 01-8741 Coolant drained (20-0100).
Core plug (121) «22.2… eee eee eee ee eee remove (steps 1 and 2). Core plug hole with activator …………… clean, combination pack 002 989 09 71. Core plug hole ………..-…-00000002e coat with sealant 002 989 45 20 10 Core plug (121) 2… eee knock in with drift. Special too! 102 589 00 15 00. Sealant 2.2… eee allow to cure. Engine 2.2… eee check for signs of leaks.
abe RA 01.1113-1400/1
Special tools
Renewal
1 Use a screwdriver to knock in core plug (121) on one side far enough for it to turn.
2 Withdraw core plug (121) by gripping at the collar.
3 Thoroughly clean core plug hole. Spray the sealing surface with activator. It must be free of grease.
4 Coat core plug hole with sealant 002 989 45 20 10.
ine RA 01.1113-1400/2
5 Knock in new core plug with the drift 102 589 00 15 00 until it is flush.
Note The sealant must harden for approx. 45 minutes before pouring in coolant.
6 Run engine until it is warm and check for signs of leaks.






