Checking, tightening cylinder head bolts

WIS 01-4050

Checking, tightening cylinder head bolts – rysunek

M12 — \” Mae i}

P01-6044–53

Checking

Length (L) of cylinder head bolts check.

Note The cylinder head bolts are subject to permanent stretch each time they are tightened. If the maximum length (L) is exceeded, the bolts should be replaced. Pay attention to different versions; see note.

Tightening

Thread of cylinder head bolts and threaded holes in crankcase clean.

AN Fluids injected into the threaded holes can destroy the crankcase. Cylinder head bolts oil thread and bolt head contact surface.

wae = RA 01.1113-4050/1 tighten in stages in the order of the tightening Cylinder head bolts ……………..2–0.0. diagram, starting with 1 ist stage 55 Nm 2nd stage 90° tightening angle 3rd stage 90° tightening angle

AN The cylinder head gasket is not watertight until the engine has reached its normal operating temperature and the gasket has swollen. For this reason, do not pressure-test cooling system until the engine has reached its operating temperature.

Tightening torques in Nm ©

Cylinder head bolts when engine cold 1st stage 55 2nd stage 90° tightening angle 3rd stage 90° tightening angle

Length of cylinder head bolt

Version Length (L) newMaximum length (L)
105 mm108.4 mm
102 mm105.8 mm

Modified cylinder head bolts

Checking, tightening cylinder head bolts – rysunek
Checking, tightening cylinder head bolts – rysunek

The M12 x 105 mm cylinder head bolts with washer (A) have been replaced by the M12 x 102 mm collar bolt without washer (B). The cylinder head bolts of version (A) with washers can be replaced with the version (B) without washer and vice versa.

Version (B) fitted as standard from 11/1988 up to 02/1989 and as of 11/1990.

PO1-0008–15

Checking, tightening cylinder head bolts – rysunek

Special tools

\

wae RA 01.1113-4050/3