Removing and installing coolant pump

WIS 20-2100

Removing and installing coolant pump – rysunek
Removing and installing coolant pump – rysunek

Preceding work: Tensionming device removed (13-3450). Power steering pump (29) swiveled to the side with lines connected. Aur cleaner removed (09-1051).

P20-5127–57

Coolant at radiator and crankcase ……….. drain (20-0100). If level control fitted: cover (1) remove, install. If level control fitted: high tension distributor (2) 2.2… 2… ee eee eee unscrew, tilt to the side with ignition cable connected, screw on. Heating water return pipe (27) at coolant pump (4) and viscous fan bearing bracket …… unscrew, replace seal (28), screw on. On vehicles with oil-water heat exchanger: cooling pipe (6) at coolant pump (4) and second intake manifold support ……………..5unscrew, replace seal (7), screw on. Coolant thermostat (3) ……………0— remove, replace seal (3a), install (20-1100). Coolant hoses (10) and (11) disconnect, connect.

ul =RA 20.1133-2100/1

M8 X30 screws (5) ……..–2–2 000000 e ee unscrew, screw on (25 Nm).

Installation note

Rear screws (5) because of accessibility ……. insert into tapped holes with rod magnet. Coolant pump (4) …..–….–.00200200 8 remove, install.

Note The coolant pump is located with ……….. two dowel sleeves (8). Seal (5)… ccc ec eee cee eee eee eee replace. Cooling system… 2… ee eee ee eee test for leaks (20-0170).

Tightening torque in Nm

Screws of coolant pump to crankcase 25

Special tool

Removing and installing coolant pump – rysunek

Commercially available tools

Hexagon socket wrench with 6 mm joint, 3/8”

Socket wrench hexagon 7 mm on flexible shaft eg. Hazet for hose clip with worm drive D-42857 Remscheid Order no. 426–7

waite =RA 20 1133-2100/2