Removing and installing high voltage distributor
WIS 15-3010
Operation no. of operation texts and work units or standard texts and flat rates: 15-3010.
P15-0411–57
A Pay attention to notes regarding work on breakerless transistorized ignition system (15-0505). Protective on HT distributor pull off upward by unclipping the two catches (arrows), fit on. Ignition cables 2.2.2… ee ee ee eee unplug, plug in.
Installation note
The ignition cables on the distributor cap should be installed in the order 1–3–6–2–4–5 so that the ignition cables can be properly routed.
wie =RA 15.1132-3010/1
take off by slackening the three hexagon socket Screening cap (6), distributor cap (4) screws, fit on by tightening screws.
AN When removing and installing distributor cap (4), pay particular attention to ensuring that the carbon brush does not strike the dome of the distributor rotor (2) and is damaged. Distributor rotor (2) remove from follower by slackening screws (1), fit on by tightening screws. Tightening torque 2.5 Nm. Follower 2.0.0.0… 0… cece ee eee remove by slackening hexagon socket screw, install by tightening screw. When installing, pay attention to locating pin and follower screw.
AN As two different versions of followers have been installed, pay attention to illustration note as well as to data in the table „follower versions.” Sealing washer (3) take off, insert. Check O-ring.
Note
After removing and installing the HT distributor, it is not necessary to set the ignition timing point. The ignition timing point is specified by the EZL ignition control unit.
Note The groove (5a) in the follower (5) must engage in the camshaft over the pin (arrow). Pay particular attention to the different followers (5).
wim =RA 15.1132-3010/2
Follewer versions
| Follower | 1st version | 2nd version |
| Material | Aluminium | Steel |
| Screw | M8 x 29 | M7 X26 |
| Tightening torque | 21 Nm | 16 Nm |



