Replacing rear crankshaft radial seal
WIS 03-3270
Preceding work: Operation no. of operation texts and work units or slandard texts Manual or automatic transmission removed and flat rates (26-020 or 27-600). 03-3063 ~ 03-3301 Flywheel or driven plate removed (03-4100). Two-mass flywheel removed (03-4620).
P03-5354–57
Radial shaft seal (93) …………….00.. prise out with a screwdriver
AN Do not damage crankshaft and mounting hole for radial shaft seal. Use a clean cloth as a base. Edge of mounting hole for radial shaft seal (93) deburr Contact surface of radial seal (93) at crankshaft check for groove caused by wear; if groove exists, install repair radial seal with sealing lip offset 3 mm to the inside. Inner part of insertion tool (2) …………… attach to crankshaft. Special tool 601 589 03 43 00
ee al RA 03.1123-3270/1
Sealing lip of radial shaft seal (93) ……..-… moisten with engine oil
A Do not use grease. Grease prevents the return swirl on the sealing lip of the radial shaft seal transporting back the engine oil. Radial shaft seal (93) …………….-0..- fit on to inner part of insertion tool (2) and press into end cover as far as a stop with insertion bell (1) Engine 2.2… ee ee ns run and check for jeaks (01-2240)
Special tool
\ 601589034300
Note The radial seal is pressed into the end cover flush without the use of sealant. The end cover is fixed in position on the crankcase by 2 dowel pins and bolted on.
An oil leak can be determined after spraying the cleaned and dried surrounding area with Mercedes-Benz white contrast spray 000 989 03 59.
The mounting holes in the crankshaft are designed as blind holes.
aie RA 03.11423-3270/2

