Removing and installing pistons

WIS 03-3160

Removing and installing pistons – rysunek
Removing and installing pistons – rysunek

Preceding work: Engine removed (01-0300). Cylinder head removed (01-4150). Oil pump removed (18-2100). Engine 103.984: oil shield plate removed (18-2180).

Removing pistons

Conrod bearing cap (1) ………-……00-. unscrew. Conrod (2) and conrod bearing cap (1) …….. are marked together. Conrod (2) with piston (4) ………….0006 remove upward.

Detaching, attaching piston

Piston pin retainer (5) ……….-5-..00005 press out with screwdriver.

Clean rag 2… eee ees use as base. Conrod 2… eee repair, align (03-3130). Piston rings …………2 0.0002 ee ee eee check gap and end clearance (03-3170).

aie §=RA 03.1123-3160/1

Removing and installing pistons – rysunek

Piston pin (6) and conrod bushes ………… oil. Piston (4) and conrod (2) …….-…-2200install together. The angled spray hole in the small conrod bush (arrow) and the arrow in the piston crown must be facing in direction of travel.

PO3 – 5215 – 57

Piston pin (6) 2.2.0… eee eee press in by hand. Piston pin retainer (5)… …………2000e insert into groove (arrow). Cleaned cylinder bores, conrod bearing journals, conrod bearing shells and piston (5) ………. oil.

Conrod bearing shell with oil drilling ………. install in conrod (2).

wae §=RA 03.1123-3160/2

Installing piston

Tensioning strap (7) 000 589 04 14 00 for piston ringS 2.0… cee ee ee fit on, tension. Piston (4) 2.0… eee ee ee ee install with arrow in direction of travel. Conrod (2) and conrod bearing cap (1) ….-…. install with marking (arrow) to each other. Conrod bolts (3) 002000 eee check, tighten (03-3100). Crankshaft ……….0. 0.2.02 e ee eee rotate, check clearance.

Data in mm

Piston projection 1) 0.72 – 0.92 1) The piston projection for standard, repair size and II is identical.

Special tools

Removing and installing pistons – rysunek
Removing and installing pistons – rysunek

000589041400 _/

Note AN install new pistons with piston rings in used engines only if the cylinder bore does not show any abnormal wear, is within the dimensional tolerances for cylinder shape and concentricity and the honing is visible and undamaged.

wie = RA 03.1123-3160/3

In the case of reconditioned engines, determine repair size (01-1100), then order pistons according to the valid parts documentation.

Pistons to counter increased oil

consumption, production breakpoint: 12/1992 Engine number 103.984 10 001672 103.884 12 008781 103.985 12 022060 103.987 10 001240 103.987 12 003076

mike =RA 03.1123-3160/4