| | |||
| 30-310 Removal and installation of engine longitudinal regulating shaft | |||
| | |||
| Note | |||
| | |||
| When removing transmission, remove longitudinal regulating shaft, so that bearing on front wall is not damaged by tilting of engine. | |||
| | |||
| A. Model 116.120 |  | ||
| Removal | |||
| 1 Disconnect regulating rods. 2 Turn longitudinal regulating shaft to the left until groove disengages from clip. Push longitudinal regulating shaft to the rear and remove. | |||
| | |||
 | |||
| | |||
| Installation | |||
| | |||
| 4 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Moly-kote Longterm 2. 5 Adjust throttle linkage (30-300). | |||
| | |||
| 30.8-310/1 F3 | |||
| | |||
| | |||
| B. Model 123.1 |  | ||
| Removal | |||
| 1 Remove regulating rod (5) and lock (33). 2 Slide longitudinal regulating shaft in forward direction out of bearing on front wall. Then remove toward the rear. | |||
| | |||
 | |||
| 1303" 996 V1 | |||
| | |||
| Installation | |||
| | |||
| 3 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Moly-kote Longterm 2. 4 Adjust throttle linkage (30-300). | |||
| | |||
| 30.8-310/2 F3 | |||
| | |||
| | |||
| C. Model 126.120 |  | ||
| Removal | |||
| 1 Disconnect regulating rods (5 and 61). 2 Remove lock (84), corrugated washer (83) and plastic spacing ring (32). 3 Push longitudinal regulating shaft (3) to the rear and remove. | |||
| | |||
 | |||
| | |||
| Installation | |||
| | |||
| 4 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Moly-kote Longterm 2. 5 Adjust throttle linkage (30—300). | |||
| | |||
| 30.8-310/3 F3 | |||
| | |||